Chapter 5: Troubleshooting
Operation Manual: Evolution Series
Warning Messages
Message Reason
IF YOU ARE READY TO
PERFORM HI-CAL PRESS OK.
Confirming high temperature calibration
of vessel position.
IF YOU ARE READY TO
PERFORM LOW-CAL PRESS OK.
Confirming low temperature calibration
of vessel position.
YOU ARE ABOUT TO DELETE
METHOD: METHOD_NAME
ARE YOU SURE?
Confirming deletion of method.
METHOD: METHOD_NAME
CURRENTLY EXISTS. DO YOU WANT TO
OVERWRITE?
Warning that method currently exists
and selecting YES will overwrite saved
method.
CALIBRATION CANNOT PROCEED
WHILE A TEST METHOD IS RUNNING
Unable to calibrate the unit while a test
is running.
CHANGES TO THIS PARAMETER
CANNOT BE MADE WHILE A
TEST METHOD IS RUNNING.
This parameters cannot be changed
while a test is running.
METHOD: METHOD_NAME
START TEST?
Confirm starting of test.
SELECT A METHOD TO RUN.
Attempting to run a method when no
method is active. Activate method from
the Method Listing screen.
METHOD: METHOD_NAME IS RUNNING.
ABORT AND START METHOD:
METHOD_NAME
A method is currently running.
Accepting 'YES' will abort current
method and start new method.
METHOD: METHOD_NAME
HAS BEEN CHANGED. SAVE CHANGES?
Confirm saving changes made to method
settings.
METHOD NAME: METHOD_NAME
MODIFICATION HISTORY IS FULL.
OVERWRITE OLDEST HISTORY?
The maximum of fifty saved
modification histories has been
exceeded. Selecting OK will overwrite
the oldest modification. Selecting
Cancel will revert to original method.
YOU ARE ABOUT TO
ABORT THE TEST.
PLEASE CONFIRM.
Confirm aborting method.
YOU ARE ABOUT TO
ABORT THE MANUAL TEST.
PLEASE CONFIRM.
Confirm aborting manual mode.
INCORRECT PASSWORD!
PLEASE TRY AGAIN.
Wrong password was entered.
USER: USER_NAME
CONFIRM DELETION?
Confirm user deletion.
CANNOT LOGOUT WHILE
SYSTEM IS BUSY.
Unable to logout while the system is
running (manual mode or a test
method).
To Next Page
Loading...
