Prepare - 104 JT40/JT40 All Terrain Operator’s Manual
Check Supplies and Prepare Equipment
AT Dirt Mode
• Verify unit has not been converted to JT mode. Install SaverLok
®
body, pipe loader accessories, pipe
guides, and wrench inserts for AT pipe.
• Use transition sub between All Terrain pipe and beacon housing. Select soil bit based on jobsite
conditions.
• Use appropriate anchors for jobsite conditions.
• Load All Terrain pipe and pipe box onto unit.
• Move mode selector switch to AT DIRT position.
JT Mode
• Install SaverLok
®
body, pipe loader accessories, pipe guides, and wrench inserts for JT pipe.
• Use standard transition sub and beacon housing. Select soil bit based on jobsite conditions.
• Use auger type anchors.
• Load JT pipe and pipe box onto unit.
• Move mode selector switch to JT position.
IMPORTANT: Use conversion kit (p/n 190-2715).
IMPORTANT: Do not put JT pipe into a large All Terrain pipe box. Pipe can jam and box can be
damaged. Use JT pipe box.
To Next Page
Loading...
