JT40/JT40 All Terrain Operator’s Manual Systems and Equipment - 185
Wireless Remote Controller
3. To drive machine, select the desired drive mode. Press one or both operator presence switches and
then set throttle and use the joystick to steer.
4. Shut down the transmitter by moving power/start/horn switch down until LED indicators go off.
Troubleshooting
If drilling unit does not respond as expected when using wireless ground drive, turn transmitter off and use
alternate ground drive controls.
If communication link indicator is blinking yellow, communication between transmitter and receiver has
stopped. Move wireless remote closer to machine while maintaining a safe distance. If in an area with
interference, try changing the channel (see below).
If communication link indicator is red, communication has been lost. Shut down wireless remote and restart
to try to enable communication. If that doesn’t work, contact your Ditch Witch
®
dealer.
If battery and communication link indicators both display red for several seconds and then the wireless
controller shuts off, USB key is not installed.
To change channels:
1. Turn machine ignition key on with engine off.
2. Connect harness (shown) to transmitter (2).
3. Ensure battery indicator is solid green.
4. Press the channel switch (1) until
communication link indicator begins to blink
green/yellow and then release the channel
switch.
• Rapid blinking green indicator signals
successful channel connection.
• Blinking yellow indicator signals
unsuccessful channel connection.
To Next Page
Loading...
