Ditch Witch JT40 - Recommended Lubricants;Service Key

Service - 202 JT40/JT40 All Terrain Operator’s Manual
Recommended Lubricants/Service Key
Recommended Lubricants/Service Key
Item Description
DEO
Diesel engine oil meeting or exceeding Cummins
®
20081, API CJ-4, ACEA E9
• Engine must use low SAPS oil (ash will plug aftertreatment device.)
• Use viscosity grade SAE 15W40 unless ambient temperatures below 5° F (-15° C) are expected. Lower
viscosity oils must meet the performance specifications shown above.
API American Petroleum Institute, ACEA European Automobile Manufacturer’s Association.
LRC
DEO
Diesel engine oil meeting or exceeding Cummins 20078, API CI-4, ACEA E7.
NOTICE: Shipped from factory with CJ-4 DEO. Change oil initially at 250 hrs.
Use viscosity grade SAE 15W40 unless ambient temperatures below 5° F (-15° C) are expected. Lower
viscosity oils must meet the performance specifications shown above.
API American Petroleum Institute, ACEA European Automobile Manufacturer’s Association.
DEF Diesel exhaust fluid (DEF) meeting ISO 22241-1 or DIN 70070
DEAC
Diesel engine antifreeze/coolant meeting
CES 14603
See “Approved Coolant” on page 203.
MPG Multipurpose grease. Use polyurea based NLGI GC-LB Grade 1.5 or lithium based NLGI
GC-LB Grade 2
WRG Multipurpose extreme pressure water resistant grease. Use polyurea based NLGI GC-
LB Grade 2 (p/n 255-1019)
EPS Extreme pressure spray lubricant, Lubriplate LO152-063 or equivalent (p/n 256-034)
MPL Multipurpose gear oil meeting API service classification GL-5 (SAE 80W90)
THF
Tractor hydraulic fluid, similar to Phillips 66
®
PowerTran Fluid, Mobilfluid
®
424,
Chevron
®
Tractor Hydraulic Fluid, Texaco
®
TDH Oil, or equivalent
TJC
Tool joint compound: Ditch Witch
®
standard (p/n 259-858) or environmental (p/n 256-
1005)
Check level of fluid or lubricant Check condition
Filter Change, replace, adjust, service or
test