Systems and Equipment - 184 JT40/JT40 All Terrain Operator’s Manual
Wireless Remote Controller
Wireless Remote Controller
Before each use
1. Check transmitter unit battery status.
Replace batteries if necessary. See
page 237.
2. Ensure USB key (shown) is installed. This
key is a lockout feature to prevent
unauthorized use.
Operation
1. Start the remote transmitter by moving the power/start/horn switch up until communication link
indicator is steady yellow and then blinks green. Clear wireless remote control light (page 4) will shine
on the machine being controlled.
2. Move power/start/horn switch up again with speed/direction control in neutral until horn sounds.
Equipment can be operated by remote control. Stay away.
270-6037
To help avoid injury:
• Keep drilling unit in sight at all times when using wireless remote controller.
• Keep a safe distance away from drilling unit when operating wireless remote controller.
• Ensure bystanders are not near the area the drilling unit will be driven.
• Remove strap from around neck when using wireless controller near moving parts. Place wireless
controller in storage box after use. Take care not to store with neck strap on top of switches.
EMERGENCY STOP: Press engine stop on wireless remote or machine.
IMPORTANT: Operator station must be empty to operate wireless ground drive control.
IMPORTANT: Wireless controller will shut down after one minute of inactivity. Move power/start/
horn switch up to restart.
To Next Page
Loading...
