Service - 200 JT40/JT40 All Terrain Operator’s Manual
Service Precautions
Service Precautions
Welding Precaution
Washing Precaution
Read operator’s manual. Know how to use all controls.
Your safety is at stake.
273-475
To help avoid injury:
• Unless otherwise instructed, all service should be performed with engine off.
• Refer to engine manufacturer’s manual for engine maintenance instructions.
NOTICE: Welding can damage electronics.
• Welding currents can damage electronic components. Always disconnect the ECU ground
connection from the frame, harness connections to the ECU, and other electronic components prior
to welding on machine or attachments. Connect welder ground close to welding point and make
sure no electronic components are in the ground path.
• Disconnect battery at battery disconnect switch before welding to prevent damage to battery. See
“Check Battery” on page 237.
• Do not turn off battery disconnect switch with engine running, or alternator and other electronic
devices may be damaged.
NOTICE: Water can damage electronics. When cleaning equipment, do not spray electrical components
with water.
To Next Page
Loading...
