JT40/JT40 All Terrain Operator’s Manual Systems and Equipment - 175
Pipeloader
Do not Overwork the Pipe
Never exceed the bend radius for your pipe. See “Recommended Bend Limits” on page 92. Do not
oversteer.
Pipeloader
Remove/Install Pipe Box
NOTICE: Bending pipe more sharply than recommended will damage pipe and cause failure.
Electric shock will cause death or serious injury. Stay
away.
274-049
To help avoid injury:
• Do not attempt to load and unload pipe while drilling or backreaming. Unprotected worker can be
injured by electric strike.
• On electrical jobsite, load and unload pipe only if loader is wearing electrically insulating boots and
gloves.
Crushing weight could cause death or serious injury. Stay
away.
275-326.
To help avoid injury:
• Always walk around unit and check for obstructions before moving load.
• Use crane capable of supporting the equipment's size and weight. See page 241 or measure and
weigh equipment before lifting.
• Never remove pins from ends of pipe box until you have attached lifting device. Box may fall if pipe
lift switch is pressed without end pins in place.
• Lift only one box of pipe at a time.
• Do not take your eyes off moving load. Always look in the direction load is moving.
• Never swing a load over people.
To Next Page
Loading...
