JT40/JT40 All Terrain Operator’s Manual Systems and Equipment - 177
Pipeloader
Install Pipe Box
1. Move pipe box over front and rear locating pins and lower into position. Ensure pipe box is moved all
the way to the front.
2. Install threaded caps onto pins.
3. Install pins.
4. Raise pipe with lifter on unit.
5. Remove bottom support pins from both ends of pipe box. Store support pins in pipe box storage
pockets.
Row Select
Drilling
Change row when column is empty. If automated pipeloader is being used, the main display will inform you
that it is time to select a new row. Use row select buttons to select new row. See “Select next row control”
on page 32.
Backreaming
Select next row when active column is full.
NOTICE: Pipe box should only be installed onto pipeloader when pipe box shuttle is in first row position.
IMPORTANT: Lift arms must be fully raised for pipe box to move.
IMPORTANT: Shuttle must be extended from under pipe box when row is selected.
NOTICE:
• Damage can occur when lifting with too many pipes in a column. Be aware of the number of pipes in
the column.
• Shuttle must be extended from under pipe box when row is selected.
To Next Page
Loading...
