Complete the Job - 196 JT40/JT40 All Terrain Operator’s Manual
Rinse Equipment
Rinse Equipment
Use Washwand
1. Turn fluid flow control (page 40) to low setting.
2. Connect the wash wand at quick connect (2)
at rear of unit.
3. Press wash wand switch to close discharge
valve. See “Wash wand switch” on page 23.
4. Check surroundings before pressing handle to
start pressurized fluid flow.
5. Spray water onto equipment to remove dirt
and mud. Some pressure might be needed to
remove dried mud from wrench area.
6. Release handle to stop flow.
Pressurized fluid or air could pierce skin and cause
severe injury. Refer to operator’s manual for proper use.
270-6035
To help avoid injury:
• Wear protective eyewear and clothing.
• Never use high flow when using washwand.
• Never point or aim the wand at yourself or anyone else. Keep nozzle low to the ground.
• Prime the drilling fluid pump before operating washwand. Failure to prime the drilling fluid pump will
cause flow fluctuations, which will make it difficult to control the washwand. For instructions, see
“Connect Fluid System” on page 121.
NOTICE: Do not spray water onto operator’s console. Do not spray water onto electrical center in
engine compartment. Electrical components could be damaged. Wipe down instead.
IMPORTANT: If front wrench is closed,
fluid will not flow to the wash wand.
To Next Page
Loading...
