JT40/JT40 All Terrain Operator’s Manual Systems and Equipment - 165
Downhole Tools
Dirt Housing Lid Installation
Lid Installation
1. Clean all threads, bolt holes and mating
surfaces.
2. Use removable thread locker (Loctite
®
242 or
equivalent), if desired.
3. Place lid on trough and install bolts (1).
4. Use punch holder (3) to drive roll pins (2) from
direction shown.
Lid Removal
1. Use punch holder (3) with bolt pin driver (4) to
drive out pins (2).
2. Remove bolts.
3. Remove lid.
To Next Page
Loading...
