Ditch Witch JT40 - Wireless Remote Controller Operation

JT40/JT40 All Terrain Operator’s Manual Controls - 23
Set-Up Console
2. Ignition switch To start engine, insert key and
turn clockwise.
To stop engine, turn key
counterclockwise.
IMPORTANT:
• Restart engine with ignition switch
after it has been turned off with
any remote engine stop switch.
• If wrenches are engaged when
engine is stopped with ignition
switch, wrenches will release and
then engage when unit is started.
3. Engine shutdown
override switch
If engine shutdown indicator
comes on, press to delay
engine shutdown for 30
seconds.
This control allows a temporary
override of engine shutdown.
NOTICE: After 30 seconds, engine
will again shut down unless fault
condition has been corrected.
IMPORTANT: See “Electronic
Controlled Engine Overview” on
page 191.
4. Wash wand switch To turn wash wand on, press
top.
To turn wash wand off, press
bottom.
5. Left track switch To move forward, press top.
To move backward, press
bottom.
IMPORTANT: Use track switches only
if wireless control is inoperable.
6. Right track switch To move forward, press top.
To move backward, press
bottom.
IMPORTANT: Use track switches only
if wireless control is inoperable.
Item Description Notes
c00ic178h.eps
c00ic204w.eps
c00ic147h.eps
c00ic148h.eps