30
IP2246EN
EN
11.6 Second level menu - SF (Special Functions)
Display Description
CU - Visualisation of the firmware version on the control panel
→→→ Release 1.1 [esempio]
SV - Saving user configuration on control panel storage module and/or on
microSD card
2”
[esempio]
→
→
/
→
→→
By selecting → → you can save up to 2 personalised configurations
in memory positions
and only with the storage module present on
the control panel. With a microSD on the control panel, up to 2 personalised
configurations can be saved in positions
and .
WARNING: if
→ → is selected, no user configuration can be saved
on
and .
WARNING: if the display shows
flashing, the storage module or mi-
croSD card may not be present.
Selections
available
RC - Configuration loading
2”
[esempio]
→→
/
→→→
The user configurations saved previously can be loaded - and on the
storage module of the control panel, or
and on the microSD card.
Display Description
Selections
available
ER - Deletion of a single remote control
→→
2”
EA - Total memory deletion
→→
→
2” 2”
RE - Setting memory opening from remote control
OF - Disabled
ON - Enabled When enabled (ON), the remote programming is activated.
To store new remote controls without using the control panel, refer to the remote
control instructions.
NOTE: make sure you do not accidentally memorise unwanted remote controls.
EP -Setting the coded area messages
If the possibility to receive coded messages is enabled, the control panel
will be compatible with remote controls of the “ENCRYPTED” type.
MS - Backward compatibility setting with older generation GOL4 remote controls.
NOTE: firmware version 1.6.5 or higher is required.
OF - Compatibility with old generation GOL4 and new ZEN remote controls.
ON - Compatibility with ZEN series remote controls
NOTE: MS=ON is recommended if only ZEN series remote controls are used
on the system.
Release 1.1 (example)
(example)
(example)
RO - Radio operations
SF - Special functions
To Next Page
Loading...
Need help?
General
