24 XT30 and XT50 User Guide | Digital Monitoring Products, Inc.
Transfer Controller
This option allows the transfer of all existing Z-Wave devices that are currently programmed in another
manufacturer’s Z-Wave portable controller to your system.
Note: This operation will overwrite all Z-Wave devices that are programmed in your system.
Initiate the transfer at the other manufacturer’s Z-Wave portable controller after starting the transfer on the
DMP keypad. Z-Wave devices are not overwritten until the transfer has been initiated at the other manufacturer’s
Z-Wave portable controller. The transfer should not be stopped once the process has been initiated from the other
manufacturer’s Z-Wave portable controller.
1. At ZWAVE SETUP?, press any Select Key or Area. The keypad displays ADDLISTREMOVE.
2. Press CMD again to display FAVXFER OPT.
3. Select XFER. The keypad warns you that transferring Z-Wave device information deletes all your Z-Wave
devices connected to your system.
4. Select YES to proceed.
5. Initiate the transfer at the other manufacturer’s Z-Wave portable controller. ZWAVE SETUP? displays.
Optimize
This updates communication with all Z-Wave devices. It can be used to re-establish communication after a Z-Wave
device has been moved to a dierent location. Z-Wave devices that fail to communicate during the optimize
process are not removed from panel programming.
1. At ZWAVESETUP?, press any Select Key or Area. The keypad displays ADDLISTREMOVE.
2. Press CMD to display FAVXFEROPT.
3. Select OPT. The keypad displays OPTIMIZE.
4. The keypad will display OPTIMIZESUCCESS when Z-Wave devices have been retrieved.
Remove Z-Wave Devices
1. At ZWAVESETUP?, press any Select Key or Area. The keypad displays ADDLISTREMOVE.
2. Select REMOVE.
3. Press the button on the Z-Wave device when PRESS BUTTON ON DEVICE TO REMOVE displays on the
keypad.
To Next Page
Loading...
Need help?
General
