66
Settings
Using Wi-Fi function
Connect to home network, company network, or access points for public
wireless LAN services using Wi-Fi function to use mail and Internet.
■ Reception interference caused by Bluetooth devices
The terminals Bluetooth function and wireless LAN devices use the
same frequency band (2.4 GHz).
If you use the terminal near a wireless LAN device, reception interference
may occur or the c
ommunications speed may lower. Also, you may hear
noise or have a connection problem. In these cases, do the following:
·
Keep the terminal 10 or more meters away from Bluetooth devices.
·
Within 10 meters, turn off Bluetooth devices.
Connecting automatically to an access point
You can search for and connect to an available access point.
·
If the access point supports “WPS”, connection settings can be configured
easily.
1
From the Home screen, → “基本機能/設定 (Basic
Functions/Settings)” → “Settings”
2
“Wi-Fi”
3
Tap “OFF” in “Wi-Fi” to switch it “ON”
Available access points are automatically detected and listed.
4
Tap an access point to connect to
■ Connecting to an open access point
Tap the access point to connect automatically.
■ Connecting to a secured access point
Enter a password “Connect”
·
Mark “Show password” to show entered password.
·
Mark “Show advanced options” to show setting items for
proxy setting, IP setting (DHCP/static), etc.
■ Connecting to an access point by WPS button
Tap
Press WPS button on the access point
·
The name of the WPS button on the access point may differ
depending on the manufacturer. See the instructions for the
access point.
■ Connecting to an access point by WPS PIN code
“Input WPS PIN”
Enter the displayed PIN code for the WPS in the access point.
■ Information
·
To manually scan available access points, from the Wi-Fi setting screen,
“Scan”.
·
To set Wi-Fi sleep setting, from the Wi-Fi setting screen, “Advanced”
“Keep Wi-Fi on during sleep” Tap a condition.
To Next Page
Loading...