D O D T E C H N O L O G I E S , I
Rev 12.109
Page 7
Chapter 4 – Setup & Configuration
Follow this checklist to configure the CLPX for first time operation.
Quick Setup Checklist
1. ___ Set system date and time (section 5.3.e)
2. ___ Gas selection (section 5.3.a)
3. ___ Alarm level settings (section 5.3.b)
4. ___ Install new ChemLogic tape
5. ___ Test the optical system (section 5.4.b)
6. ___ Install removable media (section 6.1)
Setup complete - Ready for monitoring.
4.1 Battery Charging
The Battery charger for the CLPX monitor is an electrical device that has not been evaluated for
intrinsic safety as an ignition source. This device is not to be used in a potentially explosive
atmosphere. Use of the CLPX or Battery charger in a flammable or explosive atmosphere may
result in ignition of the atmosphere resulting in serious injury or death.
WARNING : IF THE CLPX MONITOR DOES NOT OPERATE AS
DESCRIBED IN THESE INSTRUCTIONS, DO NOT USE THE
MONITOR. REMOVE THE UNIT FROM SERVICE AND TAG FOR
REPAIR BY AUTHORIZED PERSONNEL. FAILURE TO CONFIRM
THAT THE MONITOR IS OPERATING PROPERLY MAY RESULT
IN EXPOSING THE USER TO A HAZARDOUS ATMOSPHERE
WHICH COULD RESULT IN SERIOUS INJURY OR DEATH.
WARNING
BATTERY CAN EXPLODE, LEAK, OR CATCH ON FIRE IF
DIRECTLY EXPOSED TO HIGH TEMPERATURE, WATER, OR
FIRE, OF IF OPENED, DISASSEMBLED, OR TAMPERED WITH.
FAILURE TO HANDLE BATTERY PROPERLY MAY RESULT IN
SERIOUS INJURY.
WARNING
DISPOSE OF DAMAGED OR DEFECTIVE BATTERIES IN
ACCORDANCE WITH FEDERAL, STATE, AND LOCAL
ENVIRONMENTAL REGULATIONS. DO NOT THROW AWAY
BATTERIES AS ORDINARY TRASH. FAILURE TO HANDLE
BATTERY PROPERLY MAY RESULT IN SERIOUS INJURY.
To Next Page
Loading...