Dodge 2000 DURANGO - Page 360

wheelhouse inner panel. Tighten the nut to 11.8 N·m
(105 in. lbs.).
(7) Install and tighten the screw that secures the
right engine-to-body ground strap eyelet terminal to
the rear of the right cylinder head. On 5.2L and 5.9L
engines, tighten the screw to 10.2 N·m (90 in. lbs.).
On 4.7L engines, tighten the screw to 10.7 N·m (95
in. lbs.).
(8) Install and tighten the screw that secures the
left engine-to-body ground strap eyelet terminal to
the rear of the left cylinder head. On 5.2L and 5.9L
engines, tighten the screw to 10.2 N·m (90 in. lbs.).
On 4.7L engines, tighten the screw to 10.7 N·m (95
in. lbs.).
(9) Position the right engine-to-body ground strap
eyelet over the inboard weld stud on the right side of
the lower plenum panel.
(10) Install and tighten the nut and washer that
secures the right engine-to-body ground strap eyelet
to the inboard weld stud on the right side of the
lower plenum panel. Tighten the nut to 9 N·m (80 in.
lbs.).
(11) Install and tighten the nut and washer that
secures the left engine-to-body ground strap eyelet to
the weld stud on the left side of the lower plenum
panel. Tighten the nut to 9 N·m (80 in. lbs.).
EXHAUST SYSTEM-TO-BODY GROUND STRAP - 4.7L ENGINE
ONLY
(1) Position the exhaust system-to-body ground
strap over the top of the right frame rail.
(2) Install and tighten the screw that secures the
exhaust system-to-body ground strap eyelet terminal
to the right body sill panel. Tighten the screw to 5.0
N·m (45 in. lbs.).
(3) Position the exhaust system-to-body ground
strap eyelet terminal over the exhaust pipe clamp
U-bolt.
(4) Install and tighten the nut and washer that
secures the exhaust system-to-body ground strap eye-
let terminal to the exhaust pipe clamp. Tighten the
nut to 27.1 N·m (20 ft. lbs.).
(5) Lower the vehicle.
SPECIAL TOOLS
AUDIO SYSTEMS
Antenna Nut Wrench C-4816
8F - 20 AUDIO SYSTEMS DN
REMOVAL AND INSTALLATION (Continued)