(3) Remove the screw that secures the horn and
mounting bracket unit to the front of the left vertical
member of the radiator support.
(4) Remove the horn and mounting bracket unit
from the radiator support.
INSTALLATION
(1) Position the horn and mounting bracket unit
onto the front of the left vertical member of the radi-
ator support.
(2) Install and tighten the screw that secures the
horn and mounting bracket unit to the radiator sup-
port. Tighten the screw to 10.7 N·m (95 in. lbs.).
(3) Reconnect the headlamp and dash wire harness
connectors to the horn connector receptacles.
(4) Reconnect the battery negative cable.
DN HORN SYSTEMS 8G - 5
REMOVAL AND INSTALLATION (Continued)
To Next Page