LAMPS
TABLE OF CONTENTS
page page
SAFETY PRECAUTIONS .....................1
LAMP DIAGNOSIS .........................2
HEADLAMP ALIGNMENT ....................6
LAMP BULB SERVICE ..................... 10
LAMP SERVICE........................... 15
LAMP SYSTEMS..........................21
BULB APPLICATION ....................... 22
SAFETY PRECAUTIONS
TABLE OF CONTENTS
page
SERVICE PROCEDURES
SAFETY PRECAUTIONS ....................1
SERVICE PROCEDURES
SAFETY PRECAUTIONS
WARNING: EYE PROTECTION SHOULD BE USED
WHEN SERVICING GLASS COMPONENTS. PER-
SONAL INJURY CAN RESULT.
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
Do not use bulbs with higher candle power than
indicated in the Bulb Application table at the end of
this group. Damage to lamp and/or Daytime Run-
ning Lamp Module can result.
Do not use fuses, circuit breakers or relays hav-
ing greater amperage value than indicated on the
fuse panel or in the Owners Manual.
When it is necessary to remove components to ser-
vice another, it should not be necessary to apply
excessive force or bend a component to remove it.
Before damaging a trim component, verify hidden
fasteners or captured edges are not holding the com-
ponent in place.
DN LAMPS 8L - 1
To Next Page