Dodge 2000 DURANGO - Page 414

LICENSE PLATE LAMP BULB
REMOVAL
(1) Remove license plate lamp from rear bumper.
(2) Remove bulb socket from lamp (Fig. 6).
(3) Pull bulb from socket.
INSTALLATION
(1) Push bulb in socket.
(2) Install bulb socket in lamp.
(3) Install license plate lamp in rear bumper.
UNDERHOOD LAMP BULB
REMOVAL
(1) Insert a small flat blade in the access slot
between the lamp base and lamp lens.
(2) Pry the lamp lens upward and remove the
lamp lens (Fig. 7).
(3) Depress the bulb terminal inward (Fig. 8) to
release the bulb.
Fig. 4 Tail, Brake, Turn Signal and Back-up Lamp
Bulb
1 – TAIL, STOP AND TURN SIGNAL LAMP
2 – SOCKET
3 – BULB
Fig. 5 Pull Bulb From Socket
1 – SOCKET
2 – BULB
Fig. 6 License Plate Lamp Bulb
1 – SOCKET
2 – BULB
3 – LICENSE PLATE LAMP
Fig. 7 Underhood Lamp Lens
1 – LAMP
2 – LAMP LENS
8L - 12 LAMPS DN
REMOVAL AND INSTALLATION (Continued)