INSPECTION
Examine the friction surfaces of the clutch pulley
and the front plate for wear. The pulley and front
plate should be replaced if there is excessive wear or
scoring.
If the friction surfaces are oily, inspect the shaft
and nose area of the compressor for oil. Remove the
felt from the front cover. If the felt is saturated with
oil, the shaft seal is leaking and the compressor must
be replaced.
Fig. 28 Shaft Protector and Puller
1 – PULLER SHAFT PROTECTOR
2–JAWS
Fig. 29 Install Puller Plate
1 – BOLT
2 – PULLER PLATE AND BOLT
3 – BOLT
4–JAWS
Fig. 30 Clutch Coil Lead Wire Harness
1 – CLIP
Fig. 31 Clutch Field Coil Snap Ring Remove
1 – FIELD COIL
2 – SNAP RING
DN HEATING AND AIR CONDITIONING 24 - 39
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
