ParaMon-Pro X instruction manual DOC.60391-01/21
8.2.3 Engaging torque detection
Able to detect a point where the screw is engaged with the screw groove by monitoring torque.
To use this feature, engaging torque when the tool is matched with the screw thread should be greater
than free-run torque when the tool is activated in the air.
Sets tool speed until the engaging torque is detected.
Sets engaging torque in percentage (%) against the preset target torque
up to 50%.
Needed to detect engaging torque until the preset angle is reached after tool
operation; an error occurs if the preset angle is exceeded.
Needed to detect engaging torque until the time limit is reached after tool
operation; an error occurs if the time limit is exceeded.
Able to set whether or not the angle is reset when engaging torque is detected.
To Next Page
