DOGA BM Series - Multi-Sequence

ParaMon-Pro X instruction manual DOC.60391-01/21
52
8.4 Multi-sequence
Able to program fastening and loosening to a desired pattern in ‘Multi Sequence’.
Supports two different patterns (‘A’, ‘B’) and able to program up to 10 steps each.
Each step is comprised of a pair of command and parameter.
Command
Description
Parameter
No operation
Disables the step
Finished when ‘No Operation’ is encountered
during execution
None
Fastening
Fastens based on the preset
Sets the preset No. for fastening
End
Ends the execution
None
Delay (10ms)
Waits for the preset time
Sets delay time by 10m
100 = 1,000ms (1 sec.)
Select preset
Edits the PRESET to the set value
Substitution by ‘Fastening’ recommended
Sets the target preset No.