ParaMon-Pro X instruction manual DOC.60391-01/21
L. Automatically restart job when finished
Enabled under ‘With job’ mode only.
Able to set if the job would be automatically restarted when all job procedures are done.
Automatically restarts at the end of job process.
Does not automatically restart at the end of job process.
M. Enable backup manager
The BM has ‘Backup memory’ to back up event data.
ParaMon-Pro X gets events from the BM’s backup memory in realtime.
First, ParaMon-Pro X checks the status of backup memory before enabling the realtime event transfer of the
BM.
If the backup memory is empty, realtime transfer is immediately enabled.
If data already exist in the backup memory, however, it is needed to decide if they would be received.
Empties backup memory and enables realtime event transfer regardless of the existence of
data.
Enables the backup manager if data already exist.
The backup manager decides if they would be received by tool.
Enables realtime event transfer after completing the process depending on settings.
To Next Page
