Safety Section
-9-
Electronic Parking Brake
Push the front side of the parking brake
switch to engage the brake.
Push the rear side of the parking brake
switch to release the brake.
Applying the parking brake puts the transmission in
NEUTRAL. The parking brake must be applied when
leaving the lift truck and when starting the engine. If
the operator leaves the seat without applying the
parking brake, an audible alarm will sound.
WARNING
When leaving machine apply parking brake!
Parking brake is not automatically applied.
Alarm will sound if parking brake is not applied.
WARNING
Correct adjustment is necessary to provide
adequate braking. See the MAINTENANCE
section for adjustment procedures. The lift truck
may creep at engine idle and can cause damage,
injury or death. Always apply the parking brake
when leaving the lift truck. The parking brake is
NOT automatically applied.
To Next Page
Loading...
Need help?
General
