Maintenance Section
-139-
Checking Element
Insert a light inside the clean dry element and
examine it. Discard the element if tears, rips or
damage are found.
Wrap and store good elements in a clean, dry place.
Fuel Tank Filter Cap and Screen (If
Equipped) - Clean
Park the lift truck with the forks lowered, parking
brake applied, transmission in neutral and the
engine stopped.
1.
Remove the filter cap assembly. Clean in clean,
nonflammable solvent.
2. Dry cap assembly.
3. Install filter cap assembly.
WARNING
Fuel leaked or spilled onto hot surfaces or
electrical components can cause a fire.
4. Drain moisture and sediment from fuel tank as
required by prevailing conditions.
Seat, Hood Latch & Support
Cylinder - Check, Lubricate
Check the operation of the seat adjuster rod. Make
sure that the seat slides freely on its track.
Lightly oil the seat slider tracks if necessary.
Push the lever down to raise the hood and seat
assembly. Make certain the support cylinder will hold
the hood open.
Note: Unlock latch before pulling it - if key
equipped
To Next Page
Loading...
Need help?
General
