Maintenance Section
-165-
8. Install a new fuel filter and assemble the fuel
filter cap.
9. Connect the wire harness connector and fuel
hose connector. When connecting the fuel hose,
take care to prevent foreign material from
entering the hose.
10. After replacing the fuel filter or element, or
having exhausted fuel, it is necessary to remove
the air in the fuel system for safe engine start up.
11. Loosen the plug of air bleed port (5).
12. Press the pump (6) with your hand until the oil
comes out. In this operation, all the fuel hose (2)
and (4) must be connected.
13. Retighten the plug of air bleed port (5).
14. Check the fuel leakage.
Maintenance Interval of Fuel Filter
Maintenance Interval of Fuel Filter is different from
each region. Please check this table below and
change fuel filter.
Region
Maintenance Interval
hrs
w/o Pre Fuel
Filter
w/ Pre
Fuel
Filter
KOREA/JAPAN 1,000 1,000
NORTH AMERICA/
EUROPE
500 1,000
OTHER REGION 500 1,000
Wheel Bolts & Nuts – Inspect
Inspect Tightness
Steer Wheels
Typical Example
Inspect tightness of wheel bolts in a sequence
opposite each other 110 N·m (75 lb·ft).
Drive Wheels
Typical Example
Inspect tightness of wheel nuts in a sequence
opposite each other to 610 N·m (450 lb·ft).
To Next Page
Loading...
Need help?
General
