Maintenance Section
-148-
Every 10 Service Hours or Daily
You must read and understand the warnings and instructions contained in the Safety section of this manual,
before performing any operation or maintenance procedures.
Inspect Engine for Fluid Leaks
1.
Start the engine and allow it to reach operating
temperatures.
2.
Turn the engine off.
3.
Inspect the entire for oil and/or coolant leaks.
4.
Repair as necessary before continuing.
Engine Oil Level - Check
Raise the hood and seat assembly.
WARNING
Hot oil and components can cause personal
injury. Do not allow hot oil or components to
contact skin.
Diesel Engines
The oil level should be close as possible to upper
point of the oil dip stick. Do not refill more than upper
point.
Drive Axle Oil Level - Check
WARNING
Hot oil and components can cause personal
injury. Do not allow hot oil or components to
contact skin.
1. Start and operate the lift truck until the engine
reaches normal operating temperature.
2. Park the lift truck level with the forks lowered,
parking brake applied and the transmission
controls in NEUTRAL.
3. With the service brake applied and the engine at
low idle, shift the directional control lever to
forward and then to reverse, to fill the clutches.
4. Shift the direction control lever to the NEUTRAL
position.
5. Remove the dip stick/filter cap. Observe the oil
level.
6. Maintain the oil level between the Min and Max
marks on the dip stick/filter cap. (Based on oil
temperature of about 40 degrees)
To Next Page
Loading...
Need help?
General
