Maintenance Section
-152-
Mast Channels – Lubricate
The channels on the roller-type mast require a
break-in period. Apply a light film of lubricant on the
channels where the rollers ride. This will prevent
metal peel until the rollers set a pattern.
Brake Oil Level - Check
1. The brake reservoir is located on the left side of
the steering column.
2. Remove the filler cap.
3. Maintain the brake fluid level to the fluid level
mark on the brake system reservoir.
4. Clean and install the filler cap
Parking Brake - Inspect
Inspection from Operator's Seat, Engine
OFF
Push the front side of the parking brake switch to
engage the brake and push the rear side to release
it.
Inspection from Operator's Seat, Engine
ON
Parking Brake Switch
With the parking brake engaged, the direction
control lever in NEUTRAL and the engine running,
shift the direction control lever to FORWARD.
The lift truck should not move forward or feel like it
wants to move forward, even when the engine is
accelerated briefly.
Repeat this procedure in REVERSE. Report truck
movement or tendency to move under power with
the parking brake engaged.
To Next Page
Loading...
Need help?
General
