Maintenance Section
-144-
Carriage Roller Extrusion – Adjust
1. Set the mast vertical.
2. Lower the carriage completely.
3. On full free lift and full free triple lift models, the
bottom of the inner mast must be flush with the
bottom of the stationary mast.
4. Measure the distance from the bottom of the
inner upright to the bottom of carriage bearing.
5. The measurement (A) must be as follows in
Chart below.
2 ~ 2.5 ton
Height of carriage roller extrusion (A)
STD mast FF mast FFT mast
-6 41 41
DPF Regeneration (Stage5 Only)
DPF Regeneration - Display Pop-up
In order that the DPF system may maintain its
exhaust cleaning efficiency at a proper level, it
should be periodically initialized – “DPF
Regeneration”.
NOTICE
Keep monitoring the vehicle condition via the
SCREEN display.
•
At a workplace which is near inflammables or,
heavily populated, or an indoor space, disable the
Regeneration function.
•
Be careful of the high temperature of the exhaust
tube or other parts during Regeneration.
•
Do not operate the vehicle (e.g. pushing the
accelerator pedal) during Regeneration.
•
Do not switch off the ignition during DPF
Regeneration. The DPF System might be
damaged.
DOC & SCR Position
Overhead Guard
To Next Page
Loading...
Need help?
General
