Maintenance Section
-159-
Every 500 Service Hours or 3 Months
You must read and understand the warnings and instructions contained in the Safety section of this manual,
before performing any operation or maintenance procedures.
Air Intake System – Change
Changing Primary Element
See topic, “Air Intake System - Check, Clean” in
“When Required”
Changing Secondary Element
1. Remove the primary air cleaner element. See
topic “Servicing Filter Element.” Clean the inside
of the air cleaner housing and cover.
2. Remove the secondary element. Inspect the
gasket between the air cleaner housing and the
engine inlet. Replace the gasket if it is damaged.
NOTICE
Always replace the secondary element. Do not
attempt to reuse it by cleaning.
3. Install a new secondary element. Install a new or
cleaned primary element. Install the cover.
4. Tighten the latches.
5. Start the engine and observe the air cleaner
service indicator. If the indicator shows RED
after installing a new secondary element and a
cleaned primary (outer) element, replace the
cleaned primary filter with a new element.
6. Stop the engine. Close the hood and seat
assembly.
Engine Oil & Filter (DM02VA/P with
CJ-4 Grade Only) – Change
Refer to page 145~146, “Engine Oil & Filter (DM02VA
Engine Only) – Change.
WARNING
Hot oil and components can cause personal
injury. Do not allow hot oil or components to
contact skin.
1.
Remove the crankcase drain plug and allow oil to
drain into a suitable container. Clean and install
drain plug.
2.
Raise the hood and seat assembly.
DM02VA/P
3.
Remove and discard oil filter element.
To Next Page
Loading...
Need help?
General
