Doosan D35C-9 - Drive Axle - Inspect; Engine Oil - Change (DM02 VA;P Engine with CK-4 Grade Only); Engine Oil Filter - Change (DM02 VA;P Engine); Fuel Filter (DM02 VA;P Engine with Pre;Main Filter Only) - Change

Maintenance Section
-170-
Universal Joint – Inspect
Check the bearings for wear and damage; if any are
worn or damaged, replace them. Check for any
loose bolts, and tighten bolts if necessary.
Inject a sufficient amount of grease into the grease
nipples on the universal joint.
Drive axle – Inspect
Inspect Tightness
Check the bolt and washer for loosen bolt or nut ; if
any are worn or damaged, replace them. Check for
any loose bolts and nuts, and tighten bolts and nuts
if necessary(460
± 60 N · m or 340 ± 44 lbf · ft)
Engine Oil Filter – Change
(DM02VA/P Engine)
Refer to page 145~146, “Engine Oil & Filter
(DM02VA Engine Only) – Change.
WARNING
Hot oil and components can cause personal
injury. Do not allow hot oil or components to
contact skin.
Engine Oil – Change (DM02VA/P
Engine with CK-4 Grade Only)
Refer to page 141~142, “Engine Oil & Filter
(DM02VA Engine Only) – Change”.
WARNING
Hot oil and components can cause personal
injury. Do not allow hot oil or components to
contact skin.
Fuel Filter (DM02VA/P Engine with
Pre/Main Filter only) - Change
Refer to page 157, “ Fuel Filter (DM02VA/P Engine
with Main Filter only) – Change”
.
Maintenance Interval of Fuel Filter
Maintenance Interval of Fuel Filter is different from
each region. Please check this table below and
change fuel filter.
Region
Maintenance Interval
(
hrs
)
w/o Pre Fuel
Filter
w/ Pre Fuel
Filter
KOREA/JAPAN 1,000 1,000
NORTH
AMERICA/
EUROPE
500 1,000
OTHER REGION 500 1,000