Operation Section
-118-
How to Release the Electronic
Parking Brake
NOTICE
In the case of the electronic parking brake, it always
stays engaged when the ignition is off, regardless of
where the parking switch is positioned.
Before towing the vehicle, therefore, you have to
release the parking brake by force to prevent
excessive wear and damage on the park brake
components or tyres.
How to Release by Force
1.
Secure the wheels with blocks.
2.
Fasten M12 x 1.75 nut to the parking brake spool
under the transmission oil filter.
3.
By using a spanner, fully tighten the NUT by
rotating it clockwise until the parking brake spool
does no longer rise.
4.
Connect a tow bar to the forklift.
5.
Take out the supporting blocks and tow the
forklift slowly. Keep the towing speed no higher
than 2 km/h.
(If the wheels remain secured, repeat step 3.)
WARNING
Be sure all necessary repairs and adjustments
have been made before a lift truck that has been
towed to a service area is put back into operation.
NOTE:
On the completion of towing the forklift, you
must return the emergency-release spool
to its original position; otherwise, both the
service and parking brakes do not work.
How to Return the Electronic Parking
Brake
1. Secure the wheels with blocks.
2. By using a spanner, fully remove the nut installed
on the parking brake spool under the
transmission oil filter.
3. After starting up the forklift, take out its
supporting blocks and check that the parking
brake works normally and the parking brake
secures the forklift when on a slope.
To Next Page
Loading...
Need help?
General
