Safety Section
-29-
Do not operate forklifts near flammable or
combustible materials.
To avoid the discoloration, deformation or
combustion of materials (such as lumber, veneer
board, paper products and other similar items),
always park at least 30 cm (12 inches) away from
them.
Forklift trucks are not cars. They often have small
tires, no suspension, and are very heavy.
The forklift's center of gravity will also change when
carrying loads.
Avoid uneven bumps, pot holes and other hazards
whenever possible.
Carrying a load suspended on a chain or a cable
may unbalance a truck. Take extra care around
pedestrians with a suspended load as it may sway
or even strike them.
An unloaded forklift may be easier to tip over than a
loaded truck.
When traveling without a load, the risk of lateral
overturn is greater.
There are many special attachments available to
replace the forks on a lift truck.
All carry safety implications and special training in
their operation is highly recommended.
The counterweight draw bar should not be used for
towing the forklift or for towing another forklift.
Towing is only advised in emergencies, by trained
operators and at low speed, no faster than 2 km/h,
to a convenient location for repair.
To Next Page
Loading...
Need help?
General
