Operation Section
-89-
Starting From a 12 Volt External
Source
WARNING
Sparks occurring near the battery could cause
vapors to explode.
Always connect the external power source
ground cable to a point away from and below the
battery, and well clear of fuel system
components.
NOTICE
Do not reverse battery cables. It can cause damage
to the alternator.
Always connect the external power source cables in
parallel with the lift truck battery cables: POSITIVE
(+) to POSITIVE (+) and NEGATIVE (-) to
NEGATIVE (-).
Attach ground cable last, remove first. All lift trucks
equipped with DOOSAN built internal combustion
engines are NEGATIVE (-) ground.
After Starting the Engine
Observe all indicator lights and gauges frequently
during operation, to make sure all systems are
working properly. The entire indicator lights will
come ON with the ignition switch in the ON position
before the engine is started.
Diesel and LPG/GAS (12V)
The engine oil pressure indicator light (17), will not
come ON with the engine running, unless there is
low or no oil pressure. Stop the engine immediately,
if the light comes ON.
The alternator indicator light (2), should not come
ON during normal operation. The alternator is not
charging if the light comes ON with the engine
running.
The diesel engine water in fuel filter indicator light (1),
will not come ON with the engine running, unless
water in fuel filter exceeds 100cc. Stop the engine
immediately and drain the water if the light comes
ON.
Observe the fuel level gauge (4) for fuel level in the
tank.
The engine coolant temperature gauge pointer (5)
will be in the green band with the engine running,
unless the coolant temperature is excessive.
The transmission oil temperature gauge pointer (6)
will be in the green band with the engine running,
unless the oil temperature is excessive.
Observe the hour meter (9) to make sure it is
operating properly.
To Next Page
Loading...
