Doosan D35C-9 User Manual

Operation Section
-91-
To change the lift truck direction of travel, release the
accelerator pedal.
Push down on the service brake pedal to reduce the
lift truck speed as necessary.
Move the directional lever to the desired direction of
travel. Slowly push down on the accelerator pedal as
the lift truck changes direction.
When the direction change is completed, continue to
push down on the accelerator pedal to obtain the
desired travel speed.
To stop the lift truck when traveling in either direction,
release the accelerator pedal.
Push down on the service brake pedal and bring the
lift truck to a smooth stop.
Inching
NOTE: The purpose of the inching pedal is to
provide precise lift truck inching control at
very slow travel speed and high engine rpm.
This is used for fast hydraulic lift, during
load approach, pick up or load positioning.
1. To inch (creep) in either direction, slowly push
down on the inching pedal. This will start to apply
the service brakes and allow the transmission
clutch discs to slip.
2. Vary the position of the inching pedal and the
accelerator pedal to control the inching speed and
distance.
3. Pushing down further on the inching pedal will
disengage the transmission completely and apply
the service brakes fully to stop and hold the lift
truck. This will provide full engine power for fast
hydraulic lift.
4. Avoid overuse of the inching pedal as this may
cause the automatic transmission oil to overheat
or the clutch to slip. Do not use as a footrest or for
long periods of time.
5. If user operates continuously pushing work or
both brake pedal and accelerator pedal were
depressed at the same time, it may cause the
automatic transmission oil to overheat or the
clutch to slip.
WARNING
Do not use inching pedal instead of brake pedal.
It will give wearing to transmission clutch disc.

Doosan D35C-9 Specifications

General

Brand	Doosan
Model	D35C-9
Category	Forklifts
Language	English