46
ED900 09-2021DL4617-001
dormakaba ED900 Setup and Troubleshooting Instructions Appendix A
Parameter
Value
range
Units
Factory
setting
Description
Deactivation of drive; X, and a, trigger
type.
0 - 1
NC contact, drive function is deactivated when NC contact is open.
NO contact, drive function is deactivated when NO contact is closed.
Night-bank contact X; and , trigger
type.
0 - 1
. NO contact, night-bank function is triggered when NO contact is closed.
. Typically used when using a key switch or an access control system.
. NC contact, night-bank function is triggered when NC contact is opened.
. Typically used when connected to building management system to trigger doors
(signal normally present).
Release of hold-open system.
0 - 1
. Upgrade care Fire Protection installed, users may release hold-open by manually
moving door in closed direction.
. A manual release button is not required.
. Hold-open release by manually moving door in closed direction is deactivated.
. A manual release button is required.
Castor angle for double doors.
Primary door with astragal, angle active door must open before secondary door opens.
- °
Hinge clearance
. Clearance between hinges is critical for the calculated door angle.
. It may only have a small effect but the clearance can be adjusted in extreme cases to
improve accuracy.
. Factory setting is * , mm, /".
. With CPD doors, setting must be changed to a negative value. A learning cycle is then
required as system creates an angle table as a function of the set parameters.
±
*
mm
*
±/
*
inches
Overhead concealed mode (OHC):
Activation of permanent open via
night-bank input.
0 - 1
Function disabled.
If night-bank signal is longer than seconds, operator changes to permanent open
mode.
Overhead concealed mode (OHC):
Adjustable behavior after blockage / hold
open.
0 - 1
Standard behavior ( x restart).
Manual mode after blockage.
Reversing after trigger of approach side
safety sensor / opposite hinge side in
operating mode hd=.
0 - 1
Standard behavior, stop.
Reversing
A.. Driving parameters detail.
To Next Page
Loading...
