45
ED900 09-2021DL4617-001
dormakaba ED900 Setup and Troubleshooting Instructions Appendix A
Parameter
Value
range
Units
Factory
setting
Description
Upgrade card, barrier free toilet.
. Once upgrade card installed, parameter value will automatically change to (upgrade
card installed, function not activated).
. Activate function by changing parameter F to .
. Operator power reset is required; turn power switch off, wait s and turn power back
on.
• Upgrade card assigns inputs and outputs of the control unit with functions which are
required for this application.
Available
upgrade card
codes
(Para. A..)
, ,
,
Upgrade card DCW.
. Activate function by installing upgrade card, parameter value will automatically
change to .
• Upgrade card provides operator with DCW bus connection.
• Plug for terminal board X socket included with upgrade card.
• DCW bus enables connection of:
• Mode switch EPS DCW (max. )
• Motor lock controls SVP-S x DCW (max. )
• Motor lock SVP (max. )
• RM-ED lintel mounted smoke detector
• Key switch button ST DCW (max. )
• I/O module DCW (max. )
Available
upgrade card
codes
(Para. A..)
, ,
COM configuration interface.
0 - 1
Interface programmed for communication with dormakaba handheld.
Interface programmed for use with dormakaba TMS Soft control software.
Backcheck when door opened manually.
. Angle after which door is braked when manually opened.
. Back check level is automatically optimized during manual door opening cycles. This
function improves door braking behavior in end position so door does not move beyond
set opening angle OA
Entered value is subtracted from set opening angle OA.
. Example
• Opening angle, °
• Parameter bc, °
• Door back check starts at °.
-
(v.)
°
Door thickness.
. Parameter is entered in mm.
. Door thickness affects measured door opening angle.
. Parameter Td enables a more accurate door width to be entered, if required.
- mm
Td
-
/"
/"
A.. Driving parameters detail.
To Next Page
Loading...
