Dormakaba ED900 - Page 44

44
ED900 09-2021DL4617-001
dormakaba ED900 Setup and Troubleshooting Instructions Appendix A
Parameter
Value
range
Units
Factory
setting
Description
Power assist function.
. Force setting for Power assist function.
. Power assist function only available with hd parameter = , manual mode.
. ""; power assist function OFF; power assist function enabled for available values
greater than .
. Power assist function enabled when power assist activation angle hA reached.
. The greater the value of hF, the easier the door can be manually opened from power
assist activation angle hA.
. If power assist set too high, door can open automatically.
. Power assist function is not available
• If operator is switched off
• A smoke detector or emergency button has been triggered.

 -  
Additional power assist function support
from .
. Setting for additional power assist function support with door at .
. Power assist function only available with hd parameter = , manual mode.
. The greater the value of hS, the easier the door can be manually opened from the
closed position.

 -  
hS
A.. Upgrade card units codes.
- 
 Upgrade card not installed, function not available.
 Upgrade card installed, function not activated.
 Upgrade card installed, function activated.
 Upgrade card has been removed, function no longer available.
Upgrade card fire protection
. Activate function by installing upgrade card, parameter value will automatically
change to  (upgrade card function installed, fire protection function activated).
• Following activation, drive may be used as a electrically controlled hold-open system
according to EN , Building hardware-Electrically controlled hold-open systems
for fire/smoke door assemblies, or similar standards.
• Plug for terminal board X socket included with upgrade card.

Available
upgrade card
codes
(Para. A..)
, , 

Not used.

Not used.
 
Not used.


Not used.


A.. Driving parameters detail.