Dover HEIL Half/Pack Factor AFL - Page 144

Half/Pack
®
Issued April 2018
Body Controller Software
Copyright 2018, Heil Environmental
Printed in the U.S.A.
Body Controller Software
138
Function Logic:
Input Device
Status
I/O Address
Status
Container Light Circuit Switch
Activated
CAN
ON (CAN Control)
L08 Input Function – CAB Light Switch (CAN - In Cab Input)
This CAN control is used to turn ON/OFF the forward facing Cab Light Circuit, either from Street side or from the Curb side
of a dual control panel unit.
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Cab Light Circuit Switch
Activated
CAN
ON (CAN Control)
L09 Input Function – Curotto Can – Cover Open Switch (CAN - In Cab Input)
This CAN control is used to open the Curotto Can – Auto Cover, either from Street side or from the Curb side of a dual
control panel unit.
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Curotto Can – Cover Open
Activated
CAN
ON (CAN Control)
L10 Input Function – Curotto Can – Cover Close Switch (CAN - In Cab Input)
This CAN control is used to close the Curotto Can – Auto Cover, either from Street side or from the Curb side of a dual
control panel unit.
Condition
Modifiable Parameters
Default Setting
A
None
N/A
Function Logic:
Input Device
Status
I/O Address
Status
Curotto Can – Cover Close
Activated
CAN
ON (CAN Control)
L11 Input Function – Curotto Can – Light Enable Switch (CAN - In Cab Input)
This CAN control is used to turn ON/OFF the Curotto Can – Light, either from Street side or from the Curb side of a dual
control panel unit.