Half/Pack
®
Issued April 2018
Body Controller Software
Copyright 2018, Heil Environmental
Printed in the U.S.A.
Body Controller Software
156
Packer Retract Pressed While Retracted (standard equipment)
If the packer is fully retracted but the packer return push button is still pressed or the Packer retract Auxiliary controls
were activated, then the diagnostic message will be displayed in the Insight display.
Insight Display Illustration:
Indications: The packer was manually returned and the retract button was not released.
Disabled Functions: None.
Fault Reset: Release the packer retract button and Packer retract Auxiliary controls or check that the
packer return proximity switch is properly placed.
Auto-Pack Has Timed-Out (standard equipment)
The CORTEX Controller has a timer to monitor packer extend and packer retract operations. If the packer extend time
exceeds 35 seconds before the extend prox. switch is activated, this beep code will activate. In Auto Pack, the packer
will automatically retract. Packer extend may time out when the body is full or when operated at Engine idle (low
hydraulic pump flow.)
Insight Display Illustration:
To Next Page
Loading...