Half/Pack
®
Issued April 2018
Body and Tailgate
Copyright 2018, Heil Environmental
Printed in the U.S.A.
Body and Tailgate
42
CUROTTO-CAN TOP WEEKLY CHECKS
Always complete an Operational Lock-Out/Tag-Out before starting inspection. If any check does not complete
successfully the Curotto-Can must be repaired before use otherwise the Warranty is void and equipment damage or
operator injury could result.
GRAVITY HINGE CLEARANCE CHECK
1. Retract arm and slide fully.
2. Complete Operational Lock-Out/Tag-Out procedure.
3. Make sure that the tab swings freely into the pocket with
a 3/8" to 1/2" gap.
The specified gap prevents the face of the gripper head from
traveling outboard of the fork pocket.
WEAR STRIP DEPTH CHECK
1. Fully extend slide out.
2. Complete Operational Lockout.
3. Check the four (4) wear strips. If depth in any one hole is
less than 1/16” replace entire wear strip.
4. Also check each bolt for tightness.
5. When replacing wear strips use Loctite on all fasteners.
GRIP CYLINDER BOLT CHECK
1. Slightly open the grippers so that they are 2” from the
stop pads.
2. Lift up and down on the front end of the gripper arms.
3. Arms and pivots should feel tight.
4. If loose tighten the grip cylinder bolt.
5. Use Loctite on grip cylinder bolt.
To Next Page
Loading...