112 Dover Fueling Solutions W2940305 Rev 07 8/2019
Ethernet
Switch
"From Server"
Port
iX
Board
S1 Dispenser
S1 Dispenser
S1 Dispenser
iX
Board
iX
Board
iX
Board
iX
Board
iX
Board
iX
Board
Port
"From Server"
Port
"From Server"
Port
"From Server"
Port
"From Server"
Port
"From Server"
Port
"From Server"
Port
"From Server"
Connections Made via LAN
Direct Connection via Ethernet Switch
Multiple Dispensers, Dispensers Looped, Direct ConnectionSingle Dispenser, Direct Connection
Ethernet Field
Ethernet
Switch
Wiring
LAN
Ethernet
Switch
Ethernet
Switch
Inside
Outside
Wiring
Ethernet Field
Wiring
Ethernet Field
iX Fleet
Fuel
Controller
Ethernet Field
Wiring
Inside
iX Fleet
Fuel
Controller
iX Fleet
Fuel
Controller
iX Fleet
Fuel
Controller
Ethernet Field
Wiring
Ethernet Field
Wiring
Wiring
Ethernet Field
Ethernet Field
Wiring
Outside
Inside
Outside
Inside
Outside
S1 Dispenser
iX
Board
Ethernet
Switch
Ethernet
Switch
Ethernet
Switch
Ethernet
Switch
Ethernet
Switch
Distance The maximum distance recommended for a single Ethernet hardwired run is
100 meters (328 feet). Distances exceeding this length must employ a switch
or some type of repeater device within every 100 meters. DFS recommends
that for sites exceeding 200 meters from the controller to the furthest dispenser
(even with multiple switches/repeaters) or for systems requiring more than 2-3
switches/repeaters in the same line that a network engineer be used to design
and test the site. Home runs to a centralized switch are recommended
whenever possible to minimize the impact of a potential defective switch (or
repeater). Wireless modems can be used to handle long runs.
Site Layout The number of dispensers, the configuration of the dispensers, the on-site
hardware, and the desired method of connecting the dispensers together will
determine the Ethernet connections.
Rear of iX Fleet Controller
Ethernet Ports
Ethernet Switch in Dis
ense
“From Server”
Port
Ports from iX Boards or
Other Dis
ensers
To Next Page
Loading...
Need help?
General
