134 Dover Fueling Solutions W2940305 Rev 07 8/2019
Code Erro
Description
77 Additive Error
Device #s:
0=Config error
1=CAN comm error
2=Tank empty
3=Tank door open
4=Motor failure
5=Injection fell short
6=Flow error
0=Additive config conflict
1=No response from additive
2=Tank reported empty
3=Tank door reported open
4=Additive motor not turning
5=Additive injector not able to keep up w/ flowrate
6=Additive flow not detected
80 Software exception encountered
0=Mail buffer pool exhausted
1=Mail send failed
2=XMalloc failed
3=Print buffer overflow
Internal iGEM board error indication
90 Fuel temperature board communication
failure
iGEM has lost communication with the FTB, Fuel
Temperature Board
91 Fuel temperature board temperature probe
shorted
Defective or out of range probe detected by the
FTB
92 Fuel temperature board temperature probe
shorted
Defective or out of range probe detected by the
FTB
94 ATC configuration error ATC function data programmed incorrectly
95 Fuel Temp Board Calib error
96 Dispenser security breached
Device numbers:
1=Bezel door
2=Hydraulic door
Door sensor switch activity detected while armed
97 Dispenser security armed status change
Device numbers:
0=Dispenser unarmed
1=Dispenser armed using One-Shot
2+Dispenser armed using Maint Mode
Date/Time that door security was armed/unarmed
98 DEF errors, Device (D), Side (S) DEF errors
99 Hardware/Software mismatch – Device #s:
0=No proportional hardware, 1=No vapor
recovery hardware, 2=Meter does not
match F16.04, 3=Ovation II not enough
upd’s installed, 4=Ovation II too many
upd’s installed
Hardware configuration problem detected.
Hardware signal is missing
To Next Page
Loading...
