Draytek Vigor2120n-plus - Page 556

Vigor2120 Series User’s Guide
540
isolate [ssid_num lan
member]
It means to isolate the wireless connection for LAN and/or
Member.
lan – It can make the wireless clients (stations) with
remote-dial and LAN to LAN users not accessing for each
other.
member – It can make the wireless clients (stations) with the
same SSID not accessing for each other.
dtim [value]
It means to input DTIM value.
Adjustable value is “1~255”.
dtim show
It means to display current DTIM value.
beaconperiod
It means to set beacon period.
Adjustable value is “20~1023”. Unit is milli-second.
beaconperiod show
It means to display current beaconperiod value.
radio [enable]
It means to enable wireless Wi-Fi function.
1: enable
0: disable
raido show
It means to display current status of Wi-Fi function.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> wl config mode 11bgn
Current mode is 11bgn
% <Note> Please restart wireless after you set the channel
> wl config channel 13
Current channel is 13
% <Note> Please restart wireless after you set the channel.
> wl config preamble 1
Long preamble is enabled
% <Note> Please restart wireless after you set the parameters.
> wl config ssid 1 enable dray
SSID Enable Hide_SSID Name
1 1 0 dray
% <Note> Please restart wireless after you set the parameters.
> wl config security 1 wpa1x
%% Configured Wlan Security Setting:
% SSID1
%% Mode: wpa1x
%% Wireless card must be reset for configurations to take effect
%% (Telnet Command: wl restart)