VigorSwitch G2080 User’s Guide
13
Configuring the Management Agent of VigorSwitch G2080 through the Ethernet Port
There are three ways to configure and monitor the switch through the switch’s Ethernet
port. They are CLI, Web browser and SNMP manager. The user interface for the last one is
NMS dependent and does not cover here. We just introduce the first two types of
management interface.
Managing VigorSwitch G2080 through Ethernet Port
Before you communicate with the switch, you have to finish the
configuration of the IP address or to know the IP address of the switch. Then, follow the
procedures listed below.
1. Set up a physical path between the configured the switch and a PC by a qualified UTP
Cat. 5 cable with RJ-45 connector.
Note: If PC directly connects to the switch, you have to setup the same
subnet mask between them. But, subnet mask may be different for the PC in
To Next Page
Loading...
Need help?
General