VigorSwitch G2080 User’s Guide
99
3
3
.
.
1
1
7
7
.
.
2
2
E
E
m
m
a
a
i
i
l
l
/
/
S
S
M
M
S
S
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
Function name:
Email/SMS Configuration
Function description:
Alarm configuration is used to configure the persons who should receive the alarm
message via either email or SMS, or both. It depends on your settings. An email address or
a mobile phone number has to be set in the web page of alarm configuration (See Fig. 3-60).
Then, user can read the trap information from the email or the mobile phone. This function
provides 6 email addresses and 6 mobile phone numbers at most. The 24 different trap
events will be sent out to SNMP Manager when trap event occurs. After ticking trap events,
you can fill in your desired email addresses and mobile phone numbers. Then, please click
<Apply> button to complete the alarm configuration. It will take effect in a few seconds.
Note: SMS may not work in your mobile phone system. It is customized for different
systems.
Parameter description:
Email: Mail Server: the IP address of the server transferring your
email.
Username: your username on the mail server.
Password: your password on the mail server.
Email Address 1 – 6: email address that would like to
receive the alarm message.
SMS: SMS Server: the IP address of the server transferring your
SMS.
Username: your username in ISP.
Password: your username in ISP.
Mobile Phone 1-6: the mobile phone number that would like
to receive the alarm message.
To Next Page
Loading...
Need help?
General