VigorSwitch G2080 User’s Guide
29
over the starting time, the system time will be increased one
hour after one minute at the time since it passed over. And
when the time passes over the ending time, the system time
will be decreased one hour after one minute at the time since
it passed over.
The switch supports valid configurable day light saving time
is –5 ~ +5 step one hour. The zero for this parameter means
it need not have to adjust current time, equivalent to in-act
daylight saving. You don’t have to set the starting/ending
date as well. If you set daylight saving to be non-zero, you
have to set the starting/ending date as well; otherwise, the
daylight saving function will not be activated.
Default for Daylight Saving: 0.
The following parameters are configurable for the function
Daylight Saving and described in detail.
Day Light Saving Start:
This is used to set when to start performing the day light
saving time.
Mth: Range is 1 ~ 12. Default: 1
Day: Range is 1 ~ 31. Default: 1
Hour: Range is 0 ~ 23. Default: 0
Day Light Saving End:
This is used to set when to stop performing the daylight
saving time.
Mth: Range is 1 ~ 12. Default: 1
Day: Range is 1 ~ 31. Default: 1
Hour: Range is 0 ~ 23. Default: 0
To Next Page
Loading...
Need help?
General