SECTION 5 MAINTENANCE
Page 40
OM560C99/1E DRESSTA
ETHER INJECTOR
CHANGING THE FLUID CONTAINER
1. Loosen wing nuts 1 securing the fluid container support saddle 4.
2. Unscrew and discard container 2 from the ether starting valve in a suitable, closed refuse
container.
3. Install the new container 3 in the valve.
4. Secure the container in place by tightening the saddle nuts. Do not over tighten the nuts.
Fig. 5.39. Installing Ether Injector
1 - Mounting Nuts
2 - Ether Container
3 - Valve
4 - Saddle
5.13. FUEL SYSTEM
Cleanliness of diesel fuel determines the service life of the fuel injection components. Water
contaminants, allowed to reach precision injection components, cause rapid wear and poor
performance. Clean fuel and regular servicing of the fuel tank and fuel filtering components are
necessary for long service life. Always clean the area around the fuel tank filler cap before refueling.
WARNING! Do not smoke while filling the fuel tank or servicing the fuel system
because a fire or explosion could result
WARNING! When filling the fuel tank, place the fuel nozzle against the side of
the neck to reduce the chance of static electricity sparks.
WARNING! Never remove the fuel filler cap or fill the fuel tank while the engine
is running or when the machine is indoors. The fumes are hazardous and a
spark or flame can cause a fire or explosion.
WARNING! Never mix gasoline, gasohol (a mixture of corn alcohol and 90%
gasoline), or alcohol with diesel fuel. This creates a fire or explosion hazard
which could result in personal injury or death.
5.13.1. CHANGING THE FUEL FILTERS
GENERAL
The fuel fitters are spin-on type fifters. These filters cannot be cleaned and should not be disturbed
except when it becomes necessary to replace them.
To Next Page
Loading...