SECTION 4 OPERATING
Page 34
OM560C99/1E DRESSTA
PARKING THE MACHINE
Avoid parking on a slope, however, if parking on a hillside is necessary, park at the right angle to the
slope of the hill and block the tires as shown in Fig. 4.24.
ATTENTION: Avoid parking the machine in puddles of oil, grease or gasoline because this
damages the tires.
Fig. 4.24. Hillside Parking
ATTENTION: Park the machine on level ground to obtain accurate coolant, lubricant, hydraulic,
fuel level checks.
4.18. LOADER OPERATIONS
Loader equipment is hydraulically operated. When the bucket circuit is being operated, oil flow to
the boom is cut off.
4.18.1. BOOM CONTROL LEVER POSITIONS (FIGURE 4.25.)
Fig. 4.25. Boom Control Lever Positions
A. Raise
B. Hold
C. Lower
D. Float
IMPORTANT: Holding the control lever in any position except B "hold" and D “float" for an
extended period of time after the hydraulic cylinder rod has reached the limit of its travel will
produce excessive heat in the hydraulic system which may affect loader performance.
The boom control is located to the far right of the operator's seat. It has four positions: A, B, C, D
(“raise", "hold","lower", and "float")
To Next Page
Loading...