OPERATING SECTION 4
Page 15
DRESSTA OM560C99/1E
INSTRUMENTS AND CONTROLS
29. PORTABLE LAMP RECEPTACLE
Used for connecting portable lamp with cable (included in machine accessories)
30. ENGINE DIAGNOSTIC CONNECTOR
This connector is used to connect diagnostic kit (computer) for full engine diagnostics, display and
canceling faults form ECM memory.
Fig. 4.6. Side Control Panel
31. Blower Fan Control Switch
32. Heater Temperature Control Knob
33. A/C Control Knob
34. Master Switch
35. Defroster Fan Switch (If Equipped)
36. Windshield Wiper Control Switch
37. Rear Window Wipers Control Switch (If Equipped)
38. Windshield Washer Button
39. Rear Window Washer Button
40. Air Control Knob
41. Air Intake Mode Knob
31. BLOWER FAN CONTROL SWITCH
This switch controls speed of heater fan circulating air inside the cab. This switch has three
positions:
− OFF
− LO
− HI
Place the switch in the desired position.
If the outside air is extremely dusty, set the fan speed switch to the "HI" position. This will
pressurize the cab and prevent the dust from entering.
32. HEATER TEMPERATURE CONTROL KNOB
Turn the knob to the left to reduce temperature, to increase temperature turn he knob to the
right.
To Next Page
Loading...